Tuesday 22 September 2009

How to make a vaporizer with a lightbulb

Vaporizers are expensive we all know. But they give a clean hit of weed and much better to smoke than bongs and joints.

You will need:

- Standard 100w lightbulb like the one in the picture
- A plastic straw
- A plastic drinks bottle lid
- A knife
- A lighter
- A screwdriver
- Some WEED!!!

1. Firstly slice the tip off the light bulb as shown in the picture below.



Scrape out the insides and remove the filament.

2. Heat up the screwdriver and pierce the lid twice so that there are two holes, big enough to fit the straw in but air tight round the straw.

3. Place the ganj in the bulb and seal the lid over the bulb opening.

4. Chop the straw in half and place one half in each hole. One is for taking the hit one is an air inlet.

The end product should look similar to this



5. Place the lighter flame under the bulb where the weed is and slowly heat it making sure not to burn the product. If it begins to burn shake it around a little. Do all this while simultaneously inhaling the barley visible but thin smoke of the thc.

Hopefully you'll get a good hit and become mashed.

18 comments:

  1. This comment has been removed by a blog administrator.

    ReplyDelete
  2. This comment has been removed by a blog administrator.

    ReplyDelete
  3. I made one of those and they suck

    ReplyDelete
  4. will the bulb not break due to the high temperature?

    ReplyDelete
  5. i just made it, it took 20 mins to make not bad to make. quality isnt the greatest,but it does work

    ReplyDelete
  6. "Anonymous said...

    will the bulb not break due to the high temperature?"

    dude, you do realise that all light is, is a thin wire heating up so much that it glows. lights get extremely hot. and you will not break the glass without a strong jet lighter

    ReplyDelete
    Replies
    1. thats because of the vacum m8. the glass itself (without the vacum) cant handle that temprature. so yes you can easily brake your bulb vaporiver so be careful :)
      Peace dudes and dudesses, we all need it right now

      Delete
  7. That's a pretty cool trick, but why not just shell out for regular vape?

    ReplyDelete
  8. thx man that help alot when i lost my pipe

    ReplyDelete
  9. Not to get out from the topic, but i use this trick and use this small chaos for inhaling speed instead.

    and it act as pretty good water screen too. lol. thanks for the trick man.

    ReplyDelete
  10. for inhaling speed instead? disgusting.

    ReplyDelete
  11. wow great topic..you can read more here Vaporizers

    ReplyDelete
  12. This is fine blog that gives the useful knowledge How to make a vaporizer with a light bulb. Vaporizers are expensive we all know. But they give a clean hit of weed and much better to smoke than bongs and joints.

    ReplyDelete
  13. I've made a bulb vape before and they're great, work well and all.. but be warned people may call you a crackhead just because it is possible to smoke crack out of it....

    ReplyDelete
  14. This is really good published article. Such a great yet interesting post. Thank you very much for sharing this useful stuff. I had a looked for volcano vaporizer one that may also be a nice stuff.

    ReplyDelete
  15. Looks like a crack pipe

    ReplyDelete
  16. I wish more authors of this type of content would take the time you did to research and write so well. I am very impressed with your vision and insight. grav labs

    ReplyDelete

legal bud at herbalsmokeshop.com
Legal Bud