How to make a vaporizer with a lightbulb

Vaporizers are expensive we all know. But they give a clean hit of weed and much better to smoke than bongs and joints.

You will need:

- Standard 100w lightbulb like the one in the picture
- A plastic straw
- A plastic drinks bottle lid
- A knife
- A lighter
- A screwdriver
- Some WEED!!!

1. Firstly slice the tip off the light bulb as shown in the picture below.



Scrape out the insides and remove the filament.

2. Heat up the screwdriver and pierce the lid twice so that there are two holes, big enough to fit the straw in but air tight round the straw.

3. Place the ganj in the bulb and seal the lid over the bulb opening.

4. Chop the straw in half and place one half in each hole. One is for taking the hit one is an air inlet.

The end product should look similar to this



5. Place the lighter flame under the bulb where the weed is and slowly heat it making sure not to burn the product. If it begins to burn shake it around a little. Do all this while simultaneously inhaling the barley visible but thin smoke of the thc.

Hopefully you'll get a good hit and become mashed.